Quiz 2 How load balancing is achieved? Dividing packets to available nodes Prioritizing packets 1,2 None of the above Can a juniper router communicate with Cisco 7200 router? Yes No Is there any concept of load balancing in HUB? Yes off course Not at all Which protocol is most likely to use when attaching two switches? DTP VTP STP NTP Private Vlans is the recommended solution for a large complex network Yes No Which command in a switch will put STP in forwarding mode immediately? #STP fast mode #STP mode rapid-stp #STP priority 100 # STP priority 0 What does a router do in a network where different vendor devices are attached to with it? Router have a routing table as its main treasure, from which packets are delivers to its ultimate destination A router broadcast incoming traffic to its directly attached interfaces Router check the incoming traffic and send it all interfaces Cannot communicate with the other vender devices HA is the concept of switches and router No Yes How to prevent routing loops in Cisco switch 2950s No concept of routing loops in switches #routing loops stop #no routing loops None of the above WAN is used for? for wide networks for small inter network can used to communicate with LAN network All of the above Loading … Question 1 of 10
