CCNA Wireless Practice Exam 2 IUWNE 640-722 CCNA Wireless Practice Exam 2 IUWNE 640-722 Which of the following standards apply to wireless LAN operation in the 5-GHz band? a. IEEE 802.11a b. IEEE 802.11n c IEEE 802.11-2012 d. All of the above What is true? A. After a lightweight AP in its default configuration joins a controller, you can use SSH to connect to it. B. Telnet are allowed to be defaults C. Telnet and SSH are not allowed to be defaults D. All are False A wireless AP advertises mandatory data rates of 1, 2, 5.5, and 11 Mbps. Which of the following represent client data rates that can successfully join the BSS? a. Mandatory: 1 Mbps, Supported: 2, 5.5, 11 Mbps & Mandatory: 2 Mbps, Supported: 1, 5.5, 11 Mbps b. Mandatory: 2 Mbps, Supported: 1, 5.5, 11 Mbps & Mandatory: 5, 11 Mbps; Supported: None c. Mandatory: 1 Mbps, Supported: None & Mandatory: 5, 11 Mbps; Supported: None d. Mandatory: 5, 11 Mbps; Supported: None What specifies the correct list of non-overlapping channels for DSSS use in the 2.4-GHz band? a. 1, 2, 3 b. 1, 5, 10 c. 1, 6, 11 d. 1, 7, 14 Which controller logs has data about things that a controller has monitored or detected on the wireless network? a. Message log b. Trap log c. Event log d. Clean Air log A CUWN is built with one WLC and 32 lightweight APs. Which one of the following best describes the resulting architecture? a. A direct Layer 2 path from the WLC to each of the 32 LAPs, all using the same IP subnet b. A direct Layer 3 path from the WLC to each of the 32 LAPs, all using the same IP subnet c. 32 CAPWAP tunnels daisy-chained between the LAPs, one CAPWAP tunnel to the WLC d. 32 CAPWAP tunnels—one tunnel from the WLC to each LAP, with no IP subnet restrictions What is the way that an AP can learn of WLCs that it might join? a. Primed entries b. List from a previously joined controller c. DHCP d. All the above By default, which method and intervals does an AP use to detect a failed controller? a. ICMP, 60 seconds b. ICMP, 30 seconds c. CAPWAP keepalive, 60 seconds d. CAPWAP keepalive, 30 seconds Which is the most deterministic strategy you can use to push a specific AP to join a specific controller? a. Select the least-loaded controller b. Use DHCP option 43 c. Configure the master controller d. Configure the primary controller If an autonomous AP is used to support wireless clients. Which one of the following paths would traffic usually take when passing from one wireless client to another? a. Through the AP only b. Through the AP and its controller c. Through the controller only d. None of the above Loading … Question 1 of 10